Single Cylinder Dump Trailer Kit

Discussion

• From Jim at 2/10/13 8:22 PM
  • I have a question. Does the plumbing come with the kit? I see the cylinder, pump, and control, but no mention of hoses and fittings.
  • We don't sell the hoses online, as there are many different configurations, but if you call us @ 800-231-4515 we can get you taken care of.
• From jim at 3/5/13 1:25 PM
  • looking for something to configure on a tilt car trailer, 12 volt hydraulic up,gravity down possibly....30 inch ram
  • 3.5" bore cylinder should be more than enough for that.
• From Jim at 5/18/14 5:06 PM
  • I have a single cylinder dump trailer that works great for garbage but if I put dirt or gravel in it I have to shovel most of it out before it will dump. would I be better off adding another cylinder of the same size 3.5 x 30 I think or getting a 4 x 30 cylinder and replacing the one I have to get more power.
  • Either way will give you more power, but a single larger cylinder would be easier to plumb, since you could just swap them out.
• From john at 8/3/14 9:11 AM
  • How many pounds can this single cylinder kit lift? Also what's the difference between the MTE-D/A and MTE- S/A?
  • The lift capacity particularly depends on the design of the trailer, such as lift angle and hinge distance.
    
    The D/A unit is power up/power down.
    The S/A Unit is power up/gravity down.
• From Matt at 1/23/15 11:10 PM
  • What is the center to center distance of the clevis pins in the closed position for the ITR-3530?
  • Closed center-to-center is 40.25" for the ITR-3530.

Powered by Magento Discussion Extension.